V0 Printing!

 After 1.5 months of building and about 2 months of planning, the V0 24V is now printing. Had to go through a few hoops, mistakes, etc., to get to this point, but I believe it has been a rewarding experience.  Had to tweak the printer.cfg file a lot to allow for my non-standard building of using BTT SKR E3 mini V2, using a all 24V heated bed setup and using a Mosquito hot-end. Then had to customise the macros for the print start GCODES and the print end GCODES. Still some tweaking with the extruder and hot-end priming. 

It has been a great learning experience all around and the Voron community has been great - very helpful and friendly. So highly recommend that you join the Discord group if you are interested and/or building the Voron. 

First part, with some evident printing problems that needs to be resolved. The left hand side (with the inset logo) is quite a bit worse than the right hand side (with the 'Y'). The front and bottom is pretty good. The top seems to be slightly under extruded. The back side (with the 'X') looks like another print along with the left. The first layer can do with a little closer to the bed.